[Irene]
Hearing Matt's answer, you decide that you want to secure materials for a sword, although that would require going through another horde of zombies. You inwardly sigh at the prospect, but now is always better than later and you open the doors leading to the cafeteria. You decide to take the route you took when you arrived here, since all the zombies were cleared the first time around. Frolicking in the zombie-free hallway, courtesy of moi, you only encounter several when reaching the drama hallway.
How many of these darn things do I have to kill? It's like doing an Endless Brawl on Super Smash Brothers--they never stop coming!
You just dispatch the three zombies with the normal routine, using long ranged stabs with the spear and utilizing the baseball bat for closer combat. Once the hallway was cleared, you unlock and lock the door to the drama shop and quietly walk inside.
Looking around the shop, you find what you are looking for, some wood and a 1/8" thick sheet of metal. On it, you measure out a 1.75 inch wide by 29 inch long piece of metal. Carrying the metal over to the saw, you double check to make sure there is no wood nearby and put on a pair of goggles. Carefully, you turn the power saw on and feed the metal towards the blade. Sparks fly everywhere and you slowly but surely cut out the shape. Turning the saw off, you examine your handiwork. The edges were rough and so you turn your attention to the power sander. You first mark the 27 inch mark on the metal, clean the belt of any sawdust, remove anything flammable away. You gingerly pick up the metal and start sanding a slight curve onto both sides. After that's done, you sand one side into a sharp edge, but not past the 27 inch mark. Once you're done with the first side, you flip the blade over and start sanding again. For the tip, you sand an angle to it--adding a curve into it though. Examining the blade closely, you think you've done a good job.
Now for the handle. You grab a block of wood and cut it into a suitable size for a handle. You sand the handle down to make it smooth and less awkward to hold and then saunter over to the saw and cut a two inch deep slit into the wood. Inserting the blade into the handle, you see that the two reasonably fit well together. Turning to the power drill, you bore two holes near the top of the handle. You find screws and nuts and successfully attach the blade to the handle.
All that's left is making a grip and sheath. The prop room is up in the cat walks apparently, but you'll probably do that later. For now, you need some sort of sheath for the katana-like sword. Spying a roll of duct tape, you make a makeshift sheath for the sword, applying extra duct tape for the tip. This whole process takes you several hours and you glance down at your watch, "It's 12:00 a.m., and using power tools is exhausting...
You pull up several chairs in a horizontal row to sleep on. Making yourself the most comfortable as you can, you sleep.